drilling the camshaft

Hier kann über alles Mögliche geplaudert werden was mit und um unsere XL zu tun hat

Moderator: Kristian

Antworten
baldock
XL Berater
XL Berater
Beiträge: 212
Registriert: 12. Mai 2021, 20:35

drilling the camshaft

Beitrag von baldock »

The NOS camshaft was for the XL500R, but from an America model.

I now realise that it is different from the Belgium one.

has anyone drilled the hole in the camshaft before for the rev counter drive?

Any tips would be appreciated
Du hast keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Zuletzt geändert von baldock am 21. September 2021, 13:05, insgesamt 1-mal geändert.
Benutzeravatar
Gunnar_HH
XL Guru
XL Guru
Beiträge: 3807
Registriert: 16. Juli 2002, 14:42
Wohnort: Hamburg / Bramfeld

Re: drilling the camshaft

Beitrag von Gunnar_HH »

It is a pity that the borehole was forgotten.
No problem, drill it yourself. 3mm drill bit, but don't drill all the way through.
Then a 3mm dowel pin for the rev counter.

Cheers Gunnar
XL500R / Bj 82
Moto 6.5 / Bj 96
Die besten Kapitäne stehen an Land!
WAFI: Wind assisted freaking idiot
baldock
XL Berater
XL Berater
Beiträge: 212
Registriert: 12. Mai 2021, 20:35

Re: drilling the camshaft

Beitrag von baldock »

Thanks Gunnar,

I drilled it in the lathe and fitted a new dowel pin :D
Du hast keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Antworten