The NOS camshaft was for the XL500R, but from an America model.
I now realise that it is different from the Belgium one.
has anyone drilled the hole in the camshaft before for the rev counter drive?
Any tips would be appreciated
drilling the camshaft
Moderator: Kristian
drilling the camshaft
Du hast keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.
Zuletzt geändert von baldock am 21. September 2021, 13:05, insgesamt 1-mal geändert.
Re: drilling the camshaft
It is a pity that the borehole was forgotten.
No problem, drill it yourself. 3mm drill bit, but don't drill all the way through.
Then a 3mm dowel pin for the rev counter.
Cheers Gunnar
No problem, drill it yourself. 3mm drill bit, but don't drill all the way through.
Then a 3mm dowel pin for the rev counter.
Cheers Gunnar
XL500R / Bj 82
Moto 6.5 / Bj 96
Die besten Kapitäne stehen an Land!
WAFI: Wind assisted freaking idiot
Moto 6.5 / Bj 96
Die besten Kapitäne stehen an Land!
WAFI: Wind assisted freaking idiot
Re: drilling the camshaft
Thanks Gunnar,
I drilled it in the lathe and fitted a new dowel pin
I drilled it in the lathe and fitted a new dowel pin
Du hast keine ausreichende Berechtigung, um die Dateianhänge dieses Beitrags anzusehen.